Last updated: October 11, 2026

The short answer: The easiest cheap diy litter box is a large plastic storage bin with an entry cut into one side. It is roomier than most store-bought boxes, the high walls stop spraying and kicked litter, and it costs very little. Choose a bin longer than your cat, cut a wide entry at a comfortable height, sand every edge smooth, and leave the lid off.

This guide is research based. It applies the ASPCA’s litter box guidance on size and access to a simple build. It is a general how-to, not a product review.

Why Build Your Own?

  • Size. The ASPCA lists boxes that are too small among the reasons cats avoid the box. Storage bins come in sizes few litter boxes match.
  • High sides. Great for cats that stand to pee or dig hard.
  • Cost. A bin costs less than many store boxes and is easy to replace when scratched.

What You Need

  • A large, sturdy plastic storage bin. Clear or light-colored helps your cat feel less closed in.
  • A marker and tape measure.
  • A utility knife, or a hot knife made for plastic.
  • Sandpaper or a file.
  • Optional: smooth edge trim or tape for extra protection.

How to Make a Cat Litter Box From a Bin

  1. Pick the size. The bin should be clearly longer than your cat from nose to tail base, so it can turn around easily.
  2. Mark the entry on one short or long side. For most adult cats, a bottom edge a few inches above the litter line keeps litter in while staying easy to step over.
  3. Cut slowly with a sharp knife, cutting away from your hands. Warming the blade helps on thick plastic.
  4. Sand the edges until completely smooth. No sharp corners or burrs.
  5. Wash and dry the bin.
  6. Add litter about one to two inches deep, which the ASPCA says most cats prefer.
  7. Leave the lid off. The ASPCA notes most cats dislike covered boxes.

Variations

High-sided for sprayers

Keep the walls full height on three sides and cut the entry a little higher. This homemade cat litter box stops most spray and kicked litter.

Low entry for seniors

Cut the entry almost to the floor, just high enough to hold the litter. Older cats with stiff joints need an easy step. See our guide on a litter box for cats with arthritis for more.

Top entry

Cut a hole in the lid and leave the sides solid. It traps litter well, but jumping in and out does not suit kittens, seniors or large cats.

Kitten Version

A homemade litter box for kittens should be shallow and close by. A shallow plastic storage tray or a low cut-down bin works well. Keep the sides low enough for a small kitten to walk in, and place one in each room the kitten uses. A diy kitten litter box can grow with your cat if you start with a large tray and cut the entry low.

Common Mistakes

  • Choosing a bin that is too small.
  • Leaving rough edges that scratch.
  • Cutting the entry too high for your cat.
  • Using a dark, deep bin with the lid on, which feels like a trap.
  • Thin, flimsy plastic that cracks when you carry it full.

Is DIY Always Better?

For big cats and sprayers, a diy cat litter box often beats store options on size. For cats that need very low entry or easy cleaning, a purpose-built box may still be simpler. If you would rather buy, our guide to the largest cat litter box options compares ready-made picks.

Quick Answers

How to make a litter box that does not smell?

Material matters less than routine. Scoop daily and replace the bin once scratches start holding odor.

Can I make a diy kitty litter box from cardboard?

For a day or two, yes, but cardboard soaks up urine. Plastic is better for anything longer.

What about a lid?

Skip it unless you make a top entry. Most cats prefer open boxes.

The Bottom Line

A cheap diy litter box made from a large storage bin gives your cat more room for less money. Size it generously, cut a smooth entry at the right height, and keep it open and clean. More ideas are in our budget litter box ideas.

Sources

See How We Review, or visit the BestPurrPicks homepage.